When you power on the monitor and camera, the two will automatically pair. Do not place the camera and power cord within the reach of your baby.īy default, one camera has been paired with the monitor when manufactured. Only use the power adapters included in the package. Connect the camera to a power source via the Type-C cable and camera adapter.Press the Power button on the monitor to power on with the power indicator lighting green.Unplug the unit when its power indicator turns off, indicating a full charge.Of course, if you have been plugged in, it will not affect the use, but it may affect the battery life.Connect the monitor adapter to the monitor and a power outlet.Wall Mounting Threaded Holes GETTING STARTED.Power/Sleep Button: Long press to turn on/off the monitor short press to turn on/off the screen.Call key: long press to talk to the baby on the monitoring screen short press to adjust the sound or brightness of the display short press next time to enter the lullaby play page.Down Button: Press to tilt the camera downward or to change your selection downward.Confirm/Zoom Button: Press to Zoom in/out or to confirm your selection.Right Button: Press to pan the camera rightward or to change your selection rightward.Up Button: Press to tilt the camera upward or to change your selection upward.Left Button: Press to pan the camera leftward or to change your selection leftward.Camera Switch: Switch cameras if connected with two or more cameras.Menu/Back Button: Press to enter the menu page or press as a Back button.When the camera is disconnected, it flashes slowly when it enters pairing mode, it flashes quickly when the camera is turned on, it is always on. Charging Indicator: blue during charging, and goes out when fully charged Flashes red when the monitor is in a low power state.Sound Level LED: Low/high level shows low/high sound detected by the camera.Please keep them at least 1.5m / 4.9ft apart. Microphone feedback might occur when the monitor is too close to the camera.Clean the camera with a dry cloth only.Test the camera before use and after changing the camera’s location. Please check the operating range and condition of the camera carefully at the initial installation, and on a regular basis after that.Unplug the product during lightning storms.This product is not intended for use as a medical camera and its use should not replace adult supervision.You MUST check your child’s activity regularly. This product is NOT intended to replace the proper supervision of children.Unplug this device when unused for long periods of time.Only use attachments and accessories specified by the manufacturer.Do not install near any heat sources such as radiators, heat registers, stoves, or other devices that produce heat.Never use the unit near water, including near o bathtub, sink, laundry machine tube, wet basement, etc.NEVER mount the camera directly above the crib or playpen to avoid the risk of injury.NEVER place the camera or cord in or near the crib or playpen.Keep cord out of the reach of children (more than 3ft / 0.9m away) in case of STRANGULATION.13.1 Related Manuals / Resources SAFETY INSTRUCTIONS
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |